|
 |
Step-by-step instructions on how to buld a 6"x6"x3/4" Plaster/Gypsum Ant Terrarium or Habitat. |
||||||||||||||||||||
|
||||||||||||||||||||||
|
|
|
|
|||||||||||||||||||
 |
Step 1
|
|||||||||||||||||||||
Ok. First step is to make the frame seen in the image above. Unfortunately at this point I didn't take shots of the making of this since I had already had made it a while ago. Effectively it is made by cutting two pieces of the 1/2"x1" board 6 1/2" long. Then I cut a piece at least 7" long and (in my case) nailed with 1" trim nails the 6 1/2" pieces about 7" apart so as to make a U shape. Then I cut a 10" piece of the same wood and sawed out two 3/8" (thickness of wood) slots roughly 7" apart to fit the top of the U. I carved the slots carefully so the two pieces would fit snugly in the notches to make the removable frame. Once you have materials the first step is to lay down the plastic sheet (mine is 2x3'). |
||||||||||||||||||||||
| Also if you wish to purchase a Terrarium premade don't hesitate to e-mail me. The cost will be approximately $0.20/inch**2 + shipping. The fine print The really fine print Disclaimer: All statements may be proceeded with IMHO since they are all simply observations and are stated in that context only. As such fitness for any particular use or outcome are solely the responsibility of the client and as such all warranties, liabilities, possible damages resulting from the use of the information provided by ChannelU.com are to be born by the client and not the provider.. Your on your own kid ChannelU™ is a trademark of Turbo Software and it's content is under copyright© protections and may be reproduced only with written consent from Turbo Software |
||||||||||||||||||||||
